SMPP Inbound Endpoint Reference¶ The following configurations allow you to configure SMPP Inbound Endpoint for your scenario. Parameter Description Required Possible Values Default Value host IP address of the SMSC. Yes N/A N/A port Port to access the SMSC. Yes N/A N/A systemType Identifies the type of ESME system requesting to bind as a receiver with the SMSC. No "" - (NULL) CMT - Cellular Messaging CPT - Cellular Paging VMN - Voice Mail Notification VMA - Voice Mail Alerting WAP - Wireless Application Protocol USSD - Unstructured Supplementary Services Data "" - (NULL) systemId Identifies the ESME system requesting to bind as a receiver with the SMSC. Yes N/A N/A password The password may be used by the SMSC to authenticate the ESME requesting to bind. Yes N/A N/A addressNpi Numbering Plan Indicator for ESME address. Yes UNKNOWN ISDN DATA TELEX LAND_MOBILE NATIONAL PRIVATE ERMES INTERNET WAP N/A addressTon Indicates Type of Number of the ESME address. Yes UNKNOWN INTERNATIONAL NATIONAL NETWORK_SPECIFIC SUBSCRIBER_NUMBER ALPHANUMERIC ABBREVIATED N/A bindType An ESME bound as a Receiver or Transceiver is authorised to receive short messages from the SMSC. Yes BIND_RX BIND_TRX N/A addressRange A single ESME address or a range of ESME addresses served via this SMPP receiver session. No N/A null enquireLinktimer Used to check whether SMSC is connected or not. No N/A 10000 transactiontimer Time elapsed between SMPP request and the corresponding response. No N/A 200 reconnectInterval The Initial retry interval to reconnect with the SMSC while SMSC is not available. No N/A 1000ms retryCount The number of times to retry to connect with SMSC, while connection with the SMSC is closed. If you want to retry forever, give the retry count value as less than 0. No N/A 3 exponentialFactor Start with Initial reconnectInterval delay until first retry attempt is made but if that one fails, we should wait (reconnectInterval * exponentialFactor) times more. For example let’s say we start with exponentialFactor 2 and 100ms delay until first retry attempt is made but if that one fails as well, we should wait two times more (200ms). And later 400ms, 800ms… No N/A 5 maximumBackoffTime The above one is an exponential function that can grow very fast. Thus it’s useful to set maximum backoff time at some reasonable level, e.g. 10 seconds: No N/A 10000ms